Scammell Pioneer Information

The Scammell Pioneer was a British 6×4 tractor unit used in World War II as an artillery tractor, recovery vehicle and tank transporter.

Designed as a 6×4 off-road vehicle for use in Britains colonies where sealed roads were scarce, the Pioneer was first produced in 1927. Though lacking all-wheel drive, its combination of a suspension with great travel, excellent traction, and a low-revving engine gave it impressive pulling power on rough ground at low speeds.

Though not designed for military use, the British War Office purchased a single petrol engined example in 1932. Equipped as a tank transporter with a permanently coupled 18t semi-trailer, it was assigned to a training unit but did not initially catch on. Additional transporters were not purchased until 1937.

With the exception of the single 1932 tank transporter, all Pioneers purchased by the British Army were equipped with a 102 bhp Gardner 6-cylinder Diesel engine, driving the rear wheels through a constant-mesh gearbox and fitted with a power take-off driving a Scammell winch.

Introduced in 1935, the Pioneer R100 heavy artillery tractor was used throughout World War II to tow medium and heavy artillery pieces. It had accommodation for the guns crew, tools, equipment, and ammunition.

Typical early war use included towing such medium pieces as the 60-pounder, 6-inch howitzer and even the4.5-inch gun and 5.5-inch howitzer until the AEC Matador medium gun tractor was issued in sufficient numbers. Heavy artillery pieces towed included the 6-inch gun, 8-inch howitzer, 155 mm Long Tom and the 7.2-inch howitzer.

Many Pioneer gun tractors were lost in France in June 1940 with the evacuation of the British Expeditionary Force (BEF), either destroyed by the withdrawing troops or captured by the Germans.

Scammel produced 980 Pioneer R100 heavy artillery tractors by the end of the war. As this quantity was insufficient to meet requirements, the Pioneer was supplemented by the Albion CX22S heavy artillery tractor from late 1943.

From 1936, the British Army began to receive Pioneer heavy recovery vehicles. The first 43 delivered were designated the Pioneer SV1S and the Pioneer SV1T both with a 3-ton folding crane and lockers for recovery equipment and towing bars. Most of these early Pioneer recovery vehicles were lost with the BEF.

The Pioneer SV2S had a simpler redesigned extending crane that provided greater lifting height. It was Introduced in 1938 and remained in production throughout the war, with a total of 1,975 built by the end of the war.

Among the Pioneers equipment was a pair of tracks that could be fitted over the two rear wheels, converting it temporarily into a half-track and giving greater traction on soft ground.

The last Pioneer recovery vehicle was not retired from the British Army until the 1980s in Belize.

Delivery of a production tank transporter did not begin until 1937. This was equipped with a longer wheelbase for an extended cab to accommodate the tank crew as passengers and larger rear wheels than the artillery tractor and recovery vehicle variants. It was designated Pioneer TRCU20.

20- and 30-ton (Pioneer TRMU30/TRCU30) tractor/trailer combinations were delivered. In both cases, the trailer was more-or-less fixed to the tractor, not demountable like modern semi-trailer trucks. Hinged ramps were used to get the tank onto the trailer; if the tank was immobilised, it could be pulled onto the trailer with the tractor units winch.

Pioneer tractor/trailer combinations proved too tall to carry higher profile US tanks under some British bridges, resulting in their being superseded by the American Diamond T tank transporter from 1941 on. Despite this, it remained in production throughout the war, with 459 being produced. As a result of their tall profile the trailers proved undesirable postwar and most were scrapped; the tractors were retained for use with other trailers or sold into civilian use.

Complete article available at this page.