Sunday, June 16, 2019

Buffalo (mine protected vehicle) Information

June 16, 2019 Posted By AdseRudita

The Buffalo is a wheeled mine resistant ambush protected (MRAP) armored military vehicle built by Force Protection, Inc., division of General Dynamics. It is the largest vehicle in Force Protections line-up, followed by the Cougar MRAP and the Ocelot light protected patrol vehicle (LPPV).

The Buffalo vehicle was designed based on the successful South African Casspir mine-protected vehicle. The Casspir is a four-wheeled vehicle, while the Buffalo has six wheels. Buffalo is also fitted with a large articulated arm, used for ordnance disposal. Both vehicles incorporate a "V" shaped monohull chassis that directs the force of the blast away from the occupants.

Buffalo is also now equipped with BAE Systems LROD cage armor for additional protection against RPG-7 anti-tank rounds.Glass armor is sufficient at 6 inches thickness. Run-flat tires are mounted on all six wheels. The Buffalo combines ballistic and blast protection with infrared technology to detect the presence of dangerous ordnance and a robotic arm to disable the explosive ordnance. Personnel operate the Buffalo’s 30-foot robotic arm and claw from within the armored hull via a mounted camera and sensory equipment, to safely dispose of mines and IEDs.

In 2004, the United States had a limited number of Buffaloes in service, with an order for 15 more, at a cost of $10 million. On June 6, 2008 Force Protection, Inc delivered its 200th Buffalo to the U.S. Military.

In 2009 Force Protection started producing the A2 version, with major changes in the Axle Tech rear axles, Cat C13 engine, Cat CX31 transmission, and suspension, along with additional upgrades to the HVAC system, hood and front bumper. The easiest way to identify an A1 version from the A2 version is that the front bumper of the A2 has a larger profile. The last Buffalo A2 MRAP truck 795 was completed in June 2014. Force Protection was acquired by General Dynamics Land Systems (GDLS) in 2011 for $350 million.

The Buffalo appeared as the vehicle aspect of the Decepticon Bonecrusher in the movie Transformers (2007), and in the sequel, Transformers: Revenge of the Fallen. Production designer Jeff Mann stated, "We found this image of a mine-sweeping vehicle that had a huge arm with what appeared to be a fork on the end. So we called the people who owned it, hoping there was a chance we could rent it or buy it, but when we got the data, it turned out the fork was only 14 inches (360 mm) wide—they had totally cheated the whole thing in Photoshop.... We had to make an appliance to fit over the existing arm, that wouldn’t bounce around too much because it was about 10 feet (3.0 m) wide."